Das-Kit e-Bike Conversion Kit, 48V 500W

100% of 100
In stock
  • The Das-Kit eBike conversion kit installs directly on any bicycle turning it into an eBike ready to hit the road   
  • Versatile and easy to install – No heavy modifications required. Compatible with 26”, 27.5” and 29” bicycles.
  • Complete drivetrain conversion kit – Battery and charger sold separately
Das-kit conversion kit by NCM Das-kit conversion kit by NCM

Suitable for almost all bicycles, the Das-Kit conversion eBike kit is the perfect choice to power your ride. This 48v 500w drivetrain kit is complete and includes everything you need to successfully convert any bicycle into a powerful eBike. The kit includes brake levers with cut-off sensors, a 500w motor laced to your wheel size of choice that can accommodate up to a 7-speed cassette, PAS sensor, Control unit, and all connectors. Battery and charger sold separately.   



Compatible with almost every 26" / 27.5" / 29" bicycle


  • Motor Das-Kit X-15 Rear Motor Wheel (55Nm), black, 48V 500W, planetary gear
  • Sprocket Ready for freewheel sprocket (up to 7-speed) Brake 6-hole disc brake mount (disc not included), rim brake possible to be used.
  • Display & Throttle: Das-Kit Display L6. backlight, display extension cable, 6 Assistant Levels, Thumb Throttle included
  • Controller Sinus Wave Controller 31V, Current 8A, maximum current 17A (1 Sec.), Connections: Motor, Battery, Display, Front light up to 42V 
  • PAS-Disc (left side only) PAS-Disc (12 magnets) Installation on the right side of the bottom bracket. For installation on the left side, a special Hollowtech & Octalink Sensor is needed.
  • PAS-Sensor (left side only) Easy installation, for example at bicycle frame.
  • Brake Levers Artek brake levers, the cut-off sensor on the left side
  • Spokes: Stainless steel
  • Rim :hollow section type rim [black]
  • Fixing Cable ties included
  • Weight Rear wheel motor including rim: approx. 4,7kg


  • Controller: L x H x W = approx. 9cm  x 6cm x 2.7 cm
  • Rim size: 26, 27.5 or 29 inches depending on the selection
  • Cable length from Display to Controller: 190 cm
  • PAS sensor cable length: 95cm 
  • The required gap between PAS Disc and PAS sensor: approx. 5-7mm
  • Width of the rim at the outer edge: 25mm
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account